Follow along with pictures of a few music stands being built using Walnut, Curly Maple, Bubinga and Wenge.
Here we start with all the legs and centre sections freshly cut on the band saw.
I saved a beautiful piece of 3’ thick bubinga, it has some beautiful figure hidden under it’s rough exterior. I did not want to waste any of this beautiful timber so I decided to re saw the board on the band saw. This used my entire 20’’ of re saw capability.
There we have it, now for the next step.
I’ve now squared up the billets for centre sections of the base.
About to glue up the centre section, I make a half circle in each piece first then glue together to create a full circle.
These will be the centre posts, I have drilled for the dowel to reinforce the joint.
There you have it glued up and made round!
Before & after Walnut, Curly Maple & Wenge
Adding an accent piece to the top of the centre sections of the base
The one stand will have Wenge as the highlight here i’m glueing a small piece together, I don’t like to waste
There you have it highlights added to the top of each centre post, also the stopped dados have been milled
Laying out for the best possible grain flow while also avoiding defects
All four posts have now been milled round just need to be sanded
Joinery cut in the leg sections, the floating tenon be Festool
This is the clamping caul I devised to apply the pressure evenly along the joint
The coves have been added to the centre sections, they flow into each leg section
About to glue up the leg joint with floating tenons
Let the wood chips fly!
Detail shot of the highlight piece glue lines, not bad.
Another view, you can see the hole for the dowel which will attach to the sheet music holder
It’s time to glue the leg sections to the centre sections of the base
Wood rocket ships?
One last glue up for the night, can’t wait for the morning!
Clamps removed, glue up success!
Sculpted and almost all sanded
Parts for the sheet music holders
There we have it! (-:
After many many long hours almost all the pieces are fabricated
Voila almost ready for finish
Beautiful Bubinga with Wenge and brass pins for reinforcement
Before & after shaped Wenge threaded adjustment knobs
Finish applied to all the parts, we’re ready for assembly